CCNA Certification Practice Exam :
Static Routing & RIP Versions
Here's a 10-question CCNA practice exam on static routing, RIP, and distance vector protocol behavior to help you get ready for success on exam day!
When you're done here, visit our CCNA Practice Exam page for more!
Chris Bryant
CCIE #12933
"The Computer Certification Bulldog"
chris@thebryantadvantage.com
Question 1:
What command will create a static route that will route packets to only 2.2.2.2 and no other destination?
The next hop IP address for that path is 172.12.123.1, the remote router's Ethernet2 interface.
Question 2:
What command will create a static route that will send traffic destined for the 100.1.1.0 /24 network to a next-hop IP address of 172.2.2.2 ?
Assume the remote router will receive packets on its Serial3 interface.
Question 3:
What letter and/or symbol combination indicates a static host route?
Question 4:
What is the full command to disable every single one of your currently running debugs?
Question 5:
Name two routing loop prevention mechanisms built into Distance Vector protocols and briefly describe each.
Question 6:
In a RIP configuration, what value(s) can follow this command?
R2(config-router)#network 10.0.0.0
A. The subnet mask
B. The wildcard mask
C. The administrative distance of this network
D. The network mask
E. Nothing - literally!
Question 7:
What RIP-based command will hardcode each RIP-enabled interface on the router to send and accept only updates that support VLSM?
Question 8:
What command will show only the RIP-discovered routes in a routing table?
Question 9:
What's the destination address for RIP version 1 updates?
Question 10:
What's the destination address for RIP version 2 updates?
The answers are just below this brief and important message!
____________________________________________________
I'm Paying It Forward Bigger Than Before...
The CCNA Study Package Is Now $25!
"You are the reason I'm a CCNA today!" - Paul Laudenslager
____________________________________________________
|
