


	More Testimonials >

Visit my blog for free daily Cisco CCNA and CCNP certification questions, my latest free articles and tutorials, and more!

CCNP SWITCH Practice Exam

Multilayer Switching And HSRP

To prepare you for success on the CCNP SWITCH exam, here's a practice exam on multilayer switching and HSRP!

Answers can be found at the bottom of the page.

For plenty of additional CCNP SWITCH exam tutorials, videos, and practice exams, visit my CCNP SWITCH Tutorials page and my YouTube Cisco Certification Video Training page!

Enjoy the questions!

Chris Bryant

CCIE #12999

"The Computer Certification Bulldog"

chris@thebryantadvantage.com

The Only CCNP SWITCH Exam DVD From "The Computer Certification Bulldog" -- Chris Bryant, CCIE #12933.

Question 1:

In an HSRP config, R2 is the Active router. The priority is set to its default. For the Standby router to become the active router, which of these things has to happen?

A. R3's priority should be raised.

B. R3's priority should be lowered.

C. R3 should be configured with the preempt option.

D. R3 should be reloaded.

E. The reset ip hsrp process command should be run on R2 and R3.

Question 2:

Short answer: What is the default hello time of HSRP?

Question 3:

Which of the following represents multiple physical servers as a single virtual server?

A. HSRP

B. GLBP

C. VRRP

D. SLB

Question 4:

Which of the following terms best describes a Switched Virtual Interface?

A. logical, represents a switch

B. physical, represents a switch

C. logical, represents a VLAN

D. physical, represents a VLAN

Question 5:

The well-known MAC address 00-00-5e-00-0a-xx is used by which of the following?

A. HSRP

B. IRDP

C. VRRP

D. GLBP

Question 6:

Short answer: You're running HSRP interface tracking. The tracked interface goes down. What is the numeric default impact on the Active router?

Answers right after this brief, important message!

____________________________________________________

I'm Paying It Forward Bigger Than Before...

The CCNP SWITCH Exam Study Package Is Now $25!

" Your books are the best! The best money I have spent on CCNP training material!" -- Rob Pethick, CCNP

____________________________________________________

Answers:

1. "A", "C". For R3 to take over without a reload of R2, you can raise the HSRP priority of R3 from its default of 100 and configure R3 with the preempt option.

2. The default hello time of HSRP is 3 seconds. Don't confuse that with STP's hello time of 2 seconds.

3. "D". That's Server Load Balancing (SLB).

4. "C". An SVI is a logical interface that represents a VLAN.

5. "C". VRRP uses that MAC address. The "xx" at the end will be the VRRP group number expressed in hexadecimal.

6. The Active router's priority will decrement by 10.

For plenty of additional CCNP SWITCH practice exams, tutorials, and videos, just click that link for our CCNP SWITCH Exam Resource Center!