Visit my blog for free daily Cisco CCNA and CCNP certification questions, my latest free articles and tutorials, and more!
A Survival Guide To The Cisco Cable Jungle
(Now Includes A Video Tutorial!)
By Chris Bryant, CCIE #12933
One of the most confusing parts of beginning your Cisco studies is keeping all the cable types separate in your mind, and then remembering what they’re used for.
This often occurs when a CCNA or CCNP candidate starts putting together their own home practice lab, and they realize that they have the equipment to run labs, but not the cables.
With this in mind, here are some common Cisco cable types and their primary use.
First, there’s the straight-through cable, so named because the eight wires inside the cable go straight through the wire. While the wires may be twisted inside to reduce electromagnetic interference (EMI), the wire that’s connected to Pin 1 on one end is connected to Pin 1 on the other end, and so on.
In a home lab, a straight-through cable is often used to connect a switch port to an Ethernet port on a router, with a transceiver attached to the Ethernet port. Straight-through cables are also good for connecting a BRI interface to an ISDN simulator. (Note that ISDN is no longer a topic on any Cisco certification exam, including the CCNA.)
Get A Free CCNA Security Study Package With Any Purchase Of My CCNA or CCNP Study Packages or Video Boot Camps!
The crossover cable is so named because the wires do cross over between pins. This allows the devices to both send and receive at the same time, and crossover cables are a must for directly connecting ports on Cisco switches to create a trunk.
The rollover cable allows you to connect directly to a Cisco console port with your laptop or PC. This is the blue cable that comes with new Cisco devices, and it’s the one that engineers tend to hold on to with their lives. Without a rollover cable (also commonly called a “console cable”), you can’t connect your laptop directly to a Cisco device.
Finally, there’s the DTE/DCE cable.To create a frame relay cloud in your home lab (using one of your Cisco routers as a DCE), or to directly connect two Cisco routers via their serial interfaces, you will need a DTE/DCE cable. Remember that the DCE interface will need to supply clockrate to the DTE interface.
The different cable types can be confusing when you first read about them, but after tearing down or building your home lab a few times, you’ll definitely have them straight come test day!
And to help you nail the CCNA exam, here's a video tutorial on the different cable types you'll run into on your exam and in the real world - and a little additional information, too!
